SOLD
1
Used Slitting Line
1270mm x 9.5mm
BRANER
Year when built: BRANER
A Quick Tool Change Slitting Line
- TOOLED
18 t
Mode of Operation: Pull through
Materials: HRS, CRS, Alum.
Max. Coil Width: 50”
Thickness Range: .075 - .375”
Max. Coil Weight: 40,000#
Max. Shear: 45,000 PSI
Max. Yield: 45,000 PSI
Coil I.D.: Entry 19- 24”
Exit: 20”
Max. Coil O.D.: 72”
Line Direction: Right to Left
Mode of Operation: Pull through
Approx. Cut Chart (Arbor Only)
.375”- Seven (7) Cuts
.312”- Ten (10) Cuts
.250”- Fifteen (15) Cuts
.187”- Twenty-one (21) Cuts
.135”- Twenty-one (21) Cuts
EQUIPMENT LIST
Entry Turnstile
Four (4) Arms x 40,000# per Arm
Powered Rotation
Arms Slotted for C-Hooks
Entry Coil Car
Mast Type
Floor Mounted
Self-contained Hydraulics
Powered lift and traverse
Pendant Control
Cable Reel
Uncoiler Single Mandrel Type “Pumpkin Tooth” Mandrel
Hydraulic Expansion Hold Down with Powered Snubber Roll
Slide Base AC Feed-up Drive
Hydraulic Disc Brake
Peeler Assembly
Extending Blade Type Peeler
Photo Edge Guide
Tail Guard
Entry Unit- Braner
Mounted to Slitter Head
Powered Retraction to Accommodate Slitter Head Rotation
Powered Entry Pinch Rolls
Powered Side Guides
Crop Shear- Rotary Type
“Turret” Slitter Heads- Braner
Two (2) x 10” Diameter Arbor Heads
Powered Rotation Powered Outboard Retraction
Powered Top Arbor Adjust
100HP General Electric AC Motor (1200 RPM)
Carry-over Table
20’ Long
Powered Lift
Retractable Tip to feed Recoiler
Recoiler- Braner
Hydraulic Push-off
Hydraulic Expansion
Hydraulic Gripper with Double Slots
200 HP Dutch Electric DC Motor (850/1750 RPM)
Overarm Separator
Floor Mounted
Scrap Threading Slots
Exit Coil Car- Braner
Low Boy Type
Floor Mounted
Powered lift and traverse
Pendant Control
Narrow Coil Retaining Rails
Exit Turnstile
Four (4) Arms x 40,000# Per Arm
Powered Rotation
Arms Slotted for C-Hooks
Two (2) Scrap Winders
Hydraulically Powered
Level Wind
Automatic Scrap Dump
Electrical Controls
Main Operators Control Console
Auxiliary Operators Stations AC & DC Control Cabinets
CMC Emerson Spectrum DC Drive (Blown)
Slitter Tooling
Knives- 17.450" OD
½" - 183
¾" - 40
7/8" - 20
Steel Spacers
2" - 59
1" - 55
½" - 71
¼" - 102
1/8" - 96
1/16" - 138
Rubbers- Approx. 180”
Thread Guards
Misc. Separator Tooling
Two (2) Hydraulic Units
Total
We offer quality Slitting Lines both new and used / re-manufactured for Aluminium, Coated, Cold Rolled, Copper, Galvanized, Hot Rolled, Prepaint, Silicon, Stainless, Tinplate,
Your enquiries welcome for also individual Line Parts like: Decoilers, Recoilers,
Slitters, Strip Tension Stands, Turnstiles, Upenders ...